[F] Left margin
<Procedure>
(1)
While pressing [0] and [5] simultaneously, turn the power ON. (Adjustment Mode)
(2)
Open the original cover or RADF.
(3)
[SETTINGS] Set the density to the largest value and the original mode to Text.
(4)
[USER FUNCTIONS] Select [DRAWER] Select [DRAWER1] Set the paper size to A3/LD.
[OK] Set A3/LD for the paper in upper drawer.
(5)
[CANCEL] [CANCEL] Select the upper drawer by pressing [DRAWER]. Press [START]
to make copies.
(6)
Measure the blank area F at the left side of the copied image.
(7)
Check if the blank area F is within the range of 2±1.0 mm.
(8)
If not, use the following procedure to change values and measure the distance F again.
[SETTINGS] (Key in the code [4051]) [START]
(Key in a value (acceptable values: 0 to 255))
[OK] (Stored in memory)
[SETTINGS] Select the upper drawer by pressing [DRAWER]. Press [START] to make
copies.
* The larger the adjustment value is, the wider the blank area at the left side becomes (approx.
0.04 mm/step).
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
SETTING / ADJUSTMENT
Feeding direction
F
Fig.6-14
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
6 - 20