[E130] 1st drawer misfeeding
Classification
Paper misfeeding
Proce
Check item
dure
1
Open the right cover. Is
there any paper on the
transport path?
2
Is the 1st drawer feed
clutch working?
(Perform the output check
in the test mode: 03-201)
3
1st drawer feed roller
Separation roller
Parts to be replaced
MAIN board
Upper drawer feed clutch
Upper drawer feed roller
Separation roller
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
Jam not reaching the registration sensor
Result
Yes
Remove the paper.
No
Yes
No
•
Check if the connector of the 1st drawer
feed clutch is disconnected.
•
Check if any of the connectors on the MAIN
board is disconnected.
20L/23L/25L/20H/23H/25H: CN22
23LA/23LM/28LM/23HA/28HA: CN14
•
Check if the connector pins are
disconnected and the harnesses are open
circuited.
•
Check if the conductor pattern on the MAIN
board is short circuited or open circuited.
•
Replace the 1st drawer feed clutch.
•
Replace the MAIN board.
•
Check the drawer feed roller and separation
roller.
Replace them if they are worn out.
8 - 28
Error content
Measure
Remark
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Next
Step
2
3