Base Unit - Toshiba e-STUDIO2006 Service Manual

(3) Remove the side heater lamp [2] from the
rear.
Notes:
1. Hold the connector of the side heater
lamp while you remove it.
2. Be careful that the glass surface of the
side heater lamp has no fingerprints or
dirt on it.
3. When attaching the heater lamp, align the
plug with the notch of the dowel plate.
4.8.5

Base unit

(1) Take off the Center heater lamp.
 P. 4-80 "4.8.3 Center heater lamp
(LAMP1)"
(2) Take off the Side heater lamp.
 P. 4-81 "4.8.4 Side heater lamp (LAMP2)"
(3) Take off the center thermistor, side
thermistor, and edge thermistor.
 P. 4-88 "4.8.10 Center thermistor
(THMS1) / Side thermistor (THMS2) / Edge
thermistor (THMS3)"
(4) Place the fuser unit upside down.
Remove 2 screws.
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
Front side
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
4 - 82
[2]
Fig. 4-217
Fig. 4-218
Fig. 4-219