Toshiba e-STUDIO2006 Service Manual page 142

Multifunctional digital systems
Hide thumbs Also See for e-STUDIO2006:
Table of Contents

Advertisement

(5)
Remove 2 screws and take off the motor
bracket [3].
Remarks:
That shown on the right is an example of
the two-gear type.
This is the common step for both the one-
gear and two-gear types.
(6)
Release the harness from the harness guide,
and take off the scan motor [4].
Remarks:
This is the common step for both the one-
gear and two-gear types.
Notes:
When installing the scan motor, tighten
the bracket fixing screw and the earth
wire together.
When installing the gears, be sure to
check the color of gear and then place in
the correct position shown in the figure.
Remarks:
That shown on the right is an example of
the two-gear type.
This is the common step for both the one-
gear and two-gear types.
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
4 - 22
[3]
Fig. 4-54
[4]
Fig. 4-55
Fig. 4-56

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents