Toshiba e-STUDIO2006 Service Manual page 500

(6) Select the file you want to update.
(7) Click the [Update] button.
The update starts and a status bar appears on the operating panel of the equipment.
Notes:
From 1 to 2 minutes are required to update the system ROM, and about 3 minutes are required
for the engine ROM.
Notes:
The following messages appear if the program data is not transmitted correctly.
(8) When the program data transmission is completed, the message shown below appears.
(9) Turn OFF the power of the equipment.
Notes:
• It is not possible to update the system ROM and the engine ROM at the same time. Do the
updates separately.
(10) If you update the system ROM, initialize the updated data.
• Turn ON the power while [0] button and [8] button are pressed simultaneously.
• Key in "9030", and then press the [START] button.
• Press the [OK] button.
(11) When the update is finished, remove the USB cable.
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
FIRMWARE UPDATING
Fig.11-9
Fig.11-10
FIRMWARE UPDATE
FIRMWARE UPDATE OK
MACHINE POWER OFF/ON
Fig.11-11
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
11 - 10