Toshiba e-STUDIO2006 Service Manual page 221

3. Use the screw hole shown in the figure to
attach the entrance guide.
(4) Release 1 clamp [3] and remove the
harness.
(5) Release 3 clamps [4] and remove the
harness.
(6) Place the fuser unit facing the original
direction, and remove the 2 screws.
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-267
[3]
Fig. 4-268
[4]
[4]
Fig. 4-269
Fig. 4-270
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
4 - 101
DISASSEMBLY AND REPLACEMENT
4