Drum Cleaner Unit - Toshiba e-STUDIO2006 Service Manual

(5) Holding the positions shown in the figure,
pull out the process unit [3] slightly.
Notes:
1. Take care not to drop the process unit.
2. Be careful not to touch or scratch the
drum surface.
3. Avoid direct light. Place the drum in a
dark place immediately after taking off.
4.7.3

Drum cleaner unit

(1) Take off the process unit.
( P. 4-49 "4.7.1 Process unit <20L/23L/
25L/20H/23H/25H>").
( P. 4-50 "4.7.2 Process unit <23LA/23LM/
28LM/23HA/28HA>").
(2) Take off the front side stopper [1].
(3) Take off the rear side stopper [3].
Notes:
When removing the front/rear stopper, make
sure that the drum cleaner unit and
developer unit do not move from their
positions as this may damage the drum.
Remove the front/rear stopper while holding
the drum cleaner unit so that it does not
move.
(4) Take off the drum cleaner unit [4].
Notes:
1. Be careful not to touch or scratch the
drum surface.
2. Avoid direct light. Place the drum in a
dark place immediately after taking off.
3. Place the removed drum cleaner unit
facing the direction shown in the figure.
4. Keep in mind that there is a possibility
that a toner may fall, from the used toner
discharge part of a drum cleaner unit.
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-130
[1]
Fig. 4-131
[4]
Fig. 4-132
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
4 - 51
[3]
[3]
DISASSEMBLY AND REPLACEMENT
4