Fuser/Exit Unit <20L/23L/25L/20H/23H/25H> - Toshiba e-STUDIO2006 Service Manual

4.8 Fuser/Exit Unit <20L/23L/25L/20H/23H/25H>
Notes:
1. Be sure to turn the power OFF and unplug the power cable during service.
2. When disassembling the fuser unit or replacing any parts in it, be sure that the wire harness is
correctly set, and also be careful not to catch it between other parts.
a. Make sure that the terminal of the thermostat harness does not contact the metal plate.
b. Route the harness of the thermostat so that it is hooked on the notches of the rib.
c. Route the harnesses of the thermistor so that they are hooked on the housing as shown
below.
a
c
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
Fig. 4-197
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
4 - 74
b