Fuser Unit Cover/Fuser Unit Guide - Toshiba e-STUDIO2006 Service Manual

4.9.3

Fuser unit cover/Fuser unit guide

(1) Take off the fuser unit.
 P. 4-97 "4.9.1 Fuser unit"
(2) Place the fuser unit upside down.
Remove 1 screw and release the latch, take
off the bias plate [1].
(3) Remove 2 screws and then take off entrance
guide [2].
Notes:
1. When removing the entrance guide, be
careful not to scratch the fuser roller and
pressure roller with the entrance guide
edge.
2. When installing the entrance guide, make
sure that the part of the entrance guide
shown in the figure is outside the fuser
unit cover.
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
[1]
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
4 - 100
Fig. 4-264
[2]
Fig. 4-265
Fig. 4-266