Toshiba e-STUDIO2006 Service Manual page 402

[EB60] Paper left on the transport path due to multiple feeding
Classification
Paper transport jam
Proce
Check item
dure
1 Open the right cover. Is
there any paper on the
transport path?
2 Is the registration sensor
working?
(Perform the input check
in the test mode: 03-[A]/
[A])
3 Roller
Parts to be replaced
Registration sensor
MAIN board
Rollers on the transport path
[E360] Paper fed from the PFP lower drawer not reaching the PFP upper drawer feed sensor
Classification
Paper transport jam
Proce
Check item
dure
Open the PFP side cover.
1
Is there any paper in front
of the PFP upper drawer
feed sensor?
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
The multiple feeding of preceding paper caused the misfeeding of
(re-detection after no jam is detected at EB50 error)
upcoming paper
Result
Yes Remove the paper.
No
Yes
No • Check if any of the connectors on the MAIN
board is disconnected.
20L/23L/25L/20H/23H/25H: CN22
23LA/23LM/28LM/23HA/28HA: CN14
• Check if the connector of the registration
sensor is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the MAIN
board is short circuited or open circuited.
• Replace the registration sensor.
• Replace the MAIN board.
• Check the rollers. Replace them if they are
worn out.
Jam not reaching the PFP upper drawer feed sensor
Result
Yes Remove the paper.
No
8 - 24
Error content
Measure
Remark
Error content
Measure
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Next
Step
2
3
Next
Step
2