Registration roller (metal)
Main motor
drive unit
Registration roller (metal)
A:
Do not apply grease to the installation section of the registration roller clutch. Wipe
off any grease.
B:
Do not apply grease to gear teeth which contact the registration roller clutch gear.
C:
Apply a blob of grease (the size of a rice grain) to the gear teeth of the registration
roller clutch. Be careful not to use too much.
D:
Do not apply grease to the side of the registration roller clutch gear. Wipe off any
grease.
Note:
Make sure that oil is not running over or scattered around as the gear is rotated coming into the
clutch after applying Molykote to the gear which is located near the clutch. The quantity of
Molykote should be smaller than that to be applied to the other parts.
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
PREVENTIVE MAINTENANCE (PM)
Registration
roller clutch
Registration roller clutch
A
approx.
50mm
Fig. 7-13
7 - 14
Registration roller clutch
C
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
B
D