Toshiba e-STUDIO2006 Service Manual page 417

Multifunctional digital systems
Hide thumbs Also See for e-STUDIO2006:
Table of Contents

Advertisement

[E061] Incorrect paper size setting for upper drawer
[E062] Incorrect paper size setting for lower drawer
[E063] Incorrect paper size setting for PFP upper drawer
[E064] Incorrect paper size setting for PFP lower drawer
[E065] Incorrect paper size setting for bypass tray
Classification
Other jam
Check item
Paper size
[E550] Paper remaining on the transport path
Classification
Other jam
Proce
Check item
dure
Open the cover of the unit/
1
area whose picture is
blinking on the control
panel. Is there any paper
on the transport path?
Is the sensor in the
2
jamming area working?
(Perform the input check
in the test mode: refer to
the following table)
3
MAIN board
Parts to be replaced
Sensor
MAIN board
Relation between the jamming area and the corresponding sensors/Right cover
(If a jam is occurring in the ADU or PFU check the board in each unit.)
Jamming area
Registration area
Right cover
Exit area
Right cover
ADU
Right cover
PFU
PFU side cover
PFP
PFP side cover
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
The size of paper in the 1st drawer differs from size setting of the
equipment.
If any paper remains in the equipment or drawer, remove it. Match
the paper size of the drawer setting and the one in the drawer.
Paper remaining jam on the transport path
Result
Yes
Remove the paper.
No
Yes
No
Check if the connector of the sensor is
disconnected.
Check if any of the connectors on the MAIN
board is disconnected.
Check if the connector pins are
disconnected and the harnesses are open
circuited.
Check if the conductor pattern on the MAIN
board is short circuited or open circuited.
Replace the sensor.
Replace the MAIN board.
Refer to the following table
Cover
Registration sensor
Exit sensor
ADU transfer sensor
PFU drawer feed sensor
PFP upper drawer feed sensor
PFP upper lower feed sensor
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
8 - 39
Error content
Measures
Error content
Measure
Remark
Sensor
Test mode/Input check
03-[A]/[A]
03-[A]/[B]
03-[1]/[C]
03-[4]/[A]
03-[1]/[E]
03-[2]/[C]
ERROR CODE AND TROUBLESHOOTING
Next
8
Step
2
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents