[A] Reproduction ratio of primary scanning direction (Fine adjustment of image writing
frequency/PRT)
Notes:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
<Procedure>
(1)
While pressing [0] and [5] simultaneously, turn the power ON. (Adjustment Mode)
(2)
[SETTINGS] [USER FUNCTIONS] Select [DRAWER] Select [DRAWER1]
Set the paper size to A3/LD. [OK] Set A3/LD for the paper in upper drawer.
(3)
[CANCEL] [CANCEL] [SETTINGS] (Return to code entry screen)
[1] [SETTINGS] [START] (A grid pattern with 10 mm squares is printed out.)
(4)
Check the grid pattern on the test chart printed out and measure the distance A from the 1st line
to the 21st line of the grid pattern.
(5)
Check if the distance A is within 200±0.5 mm.
(6)
If not, use the following procedure to change values and measure the distance A again.
(Adjustment Mode) (Key in code [4001]) [START]
(Key in a value (acceptable values: 0 to 255))
[OK] (Stored in memory)
Press [1] Press [SETTINGS] [START] (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance A becomes (approx. 0.1 mm/step).
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
6 - 9
SETTING / ADJUSTMENT
6