Notes:
1. Be sure to install the thermistors so that
their bosses are securely inserted into the
frames.
Notes:
After the thermistors are installed in the fuser
unit, check that their gauge heads (indicated
by the red arrow) contact the fuser roller. If
there are gaps between them or the
thermistors are tilted, reinstall them.
[1] Center/Side thermistor
[2] Edge thermistor
4.9.12
Exit roller
(1)
Take off the tray rear cover.
P. 4-4 "4.1.8 Tray rear cover"
(2)
Remove 1 clip [1] and take off 1 bushing [2].
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-301
[1]
Fig. 4-302
Fig. 4-303
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
4 - 113
[2]
[2]
[1]
DISASSEMBLY AND REPLACEMENT
4