Fuser Unit - Toshiba e-STUDIO2006 Service Manual

4.9.1

Fuser unit

Notes:
As the fuser unit is hot, power OFF and make sure that the fuser unit has cooled down
sufficiently before removing.
If removing it while still hot, use gloves.
(1) Take off the right rear cover.
 P. 4-7 "4.1.11 Right rear cover"
(2) Disconnect 3 connectors [1] and release the
harness from the harness guide.
(3) Remove 2 screws.
Notes:
Note that the front side and rear side screws
are different from each other. Install the
screws in their proper locations.
Front side: Shoulder screw M3 x 6
Rear side: M3 x 10
(4) Take off the fuser unit [2].
Notes:
1. Take note that the fuser unit is hot.
Particularly, the metal sheet of the
entrance guide below the fuser unit is hot.
2. When removing the fuser unit, hold the
positions shown in the figure.
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-255
Shoulder screw
M3 x 6
Fig. 4-256
Fig. 4-257
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
4 - 97
[1]
M3 x 10
[2]
DISASSEMBLY AND REPLACEMENT
4