Assist Mode (3C) - Toshiba e-STUDIO2006 Service Manual

5.8

Assist Mode (3C)

5.8.1 Functions
This equipment has the Assist Mode to enable the following functions.
(1) Memory data format (CLEAR SRAM)
*
When the memory
memory.
Memory data must be formatted with this function for such case.
* 23LA/23LM/28LM: IC10
20L/23L/25L/20H/23H/25H,23HA/28HA: IC11
Notes:
• This function is required only when a new memory is installed.
• Do not perform this function in cases other than the installation of a new memory because all
data in the memory will be deleted with this function.
(2) Memory securely erasing (ERASE SRAM SECURELY)
It overwrites all the used areas on the memory
Immediately after selecting this function, the processing starts and is completed.
* 23LA/23LM/28LM: IC10
20L/23L/25L/20H/23H/25H,23HA/28HA: IC11
Remarks:
FIWMWARE ASSIST MODE
CLEAR SRAM
ERASE SRAM SECURELY
Though the menu includes an "SRAM" item, the machine
is actually equipped with Flash memory, not SRAM.
(3) When an F104 error has occurred, it can be removed with this function. <23LA/23LM/28LM/
23HA/28HA only>
Notes:
When the memory has been cleared in the Assist Mode (3C), check the items below and change
the value of the following codes accordingly:
• 08-3134 (Scan motor gear) <20L/23L/25L/20H/23H/25H only>
0: One-gear
1: Two-gear
• 08-9063 (Installation of the fax function)
0: Not installed
1: Installed
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
is replaced with a new one, abnormal values may be written in the new
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
5 - 13
*
with the selected data, and makes it unusable.
SELF-DIAGNOSIS MODES
5