Main Motor (M3) - Toshiba e-STUDIO2006 Service Manual

4.5 Drive System
4.5.1

Main motor (M3)

(1) Take off the rear cover.
 P. 4-5 "4.1.9 Rear cover <20L/23L/25L/
20H/23H/25H>"
 P. 4-6 "4.1.10 Rear cover <23LA/23LM/
28LM/23HA/28HA>"
(2) Disconnect 1 connector [1] and remove 2
screws. Take off the main motor [2].
4.5.2 Toner motor (M2)
(1) Take off the rear cover.
 P. 4-5 "4.1.9 Rear cover <20L/23L/25L/
20H/23H/25H>"
 P. 4-6 "4.1.10 Rear cover <23LA/23LM/
28LM/23HA/28HA>"
(2) Remove the 1 screw and disconnect 1
connector [1].
(3) Take off the toner motor [2] with the bracket,
and then remove 1 bushing [3] and 1 gear
[4].
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
[2]
[1]
[4]
[3]
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
4 - 30
Fig. 4-74
[1]
Fig. 4-75
[2]
Fig. 4-76