4.7.28
Developer sleeve <20L/23L/25L/20H/23H/25H>
(1)
Remove the developer material.
P. 4-59 "4.7.19 Removing developer
material"
(2)
Remove 1 screw and take off the polarity
adjustment lever [1].
Notes:
Make a note of the position where the
polarity adjustment lever is pointing. (Mark
the position if needed.) When reassembling,
match the polarity adjustment lever with the
previously marked position on the scale.
(3)
Release 1 latch and take off the recovered
toner supply unit [2].
(4)
Release 2 latches and take off the holder [3].
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
[2]
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
4 - 68
[1]
Fig. 4-179
Fig. 4-180
[3]
Fig. 4-181