Toshiba e-STUDIO2006 Service Manual page 68

(B) Pick-up failure in bypass
• During bypass feeding
Bypass feed clutch ON

Registration sensor is not turned ON in a fixed period of time

"Misfeed in bypass" is displayed: E120

Copying operation is disabled

Solution: Remove the paper from the bypass tray and open and close the right cover.
(C) Misfeed in equipment
• Exit sensor detects jamming of the leading edge of paper.

Registration roller clutch ON
 Less than regulation time
Exit sensor ON
If the exit sensor is not turned ON after
regulation time

Paper jam (E010) The copying operation is
stopped.
• Exit sensor detects jamming of the tailing edge of paper.

Registration roller clutch OFF
 Less than regulation time
Exit sensor OFF
If the exit sensor is not turned OFF after
regulation time

Paper jam (E020) The copying operation is
stopped.
• Immediately after the power ON

Any of all sensors on paper transport path detects paper (ON)

Paper jam (E030)
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
OUTLINE OF THE MACHINE
Registration roller
clutch
Exit sensor
Timer
Registration roller
clutch
Exit sensor
Timer
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
3 - 26
ON
ON
0
Regulation time
Paper jam (E010)
Fig. 3-24
OFF
ON
0
Regulation time
Paper jam (E020)
Fig. 3-25