Toshiba e-STUDIO2006 Service Manual page 413

[E420] PFP side cover opened during printing
Classification
Cover open jam
Proce
Check item
dure
1 Is the PFP side cover
open?
Is the PFP side cover
2
opening/closing switch
working?
(Perform the input check
in the test mode: 03-[1]/
[D])
3 Replacing board
Parts to be replaced
PFP side cover opening/closing
switch
PFP board
MAIN board
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
PFP side cover open jam
Result
Yes Remove the paper if there is any, then close
the cover.
No
Yes
No • Check if the connector of the PFP side
cover opening/closing switch is
disconnected.
• Check if either of the connectors CN410 on
the PFP board is disconnected.
• Check if any of the connectors on the MAIN
board is disconnected.
20L/23L/25L/20H/23H/25H: CN26
23LA/23LM/28LM/23HA/28HA: CN15
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the PFP
board and MAIN board are short circuited or
open circuited.
• Replace the PFP side cover opening/
closing switch.
• Replace the PFP board.
• Replace the MAIN board.
• Replace the PFP board.
• Replace the MAIN board.
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
8 - 35
Error content
Measure
Remark
ERROR CODE AND TROUBLESHOOTING
Next
Step
2
3
8