Toshiba e-STUDIO2006 Service Manual page 199

2. When installing the entrance guide, make
sure that the part of the entrance guide
shown in the figure is outside the fuser
unit cover.
3. Use the screw hole shown in the figure to
attach the entrance guide.
(4) Place the fuser unit facing the original
direction, and remove the 2 screws.
(5) Release 2 fuser unit latches and then take off
the fuser unit cover/fuser unit guide [3].
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-207
Fig. 4-208
Fig. 4-209
Fig. 4-210
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
4 - 79
[3]
DISASSEMBLY AND REPLACEMENT
4