Toshiba e-STUDIO2006 Service Manual page 144

4.3.6 Scan motor (M1) <23LA/23LM/28LM/23HA/28HA>
(1) Take off the rear cover.
 P. 4-6 "4.1.10 Rear cover <23LA/23LM/
28LM/23HA/28HA>"
(2) Disconnect 1 connector [1] from the MAIN
board (CN6).
(3) Take off the CIS case.
 P. 4-18 "4.3.3 CIS case"
(4) Remove the gear [2].
(5) Remove 2 screws and take off the motor
bracket [3].
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
4 - 24
[1]
Fig. 4-59
[2]
Fig. 4-60
[3]
Fig. 4-61