Toshiba e-STUDIO2006 Service Manual page 483

When PFU is installed:
05-4018-1 (Sideways deviation adjustment (2nd drawer)
05-4059 (Adjustment of secondary scanning laser writing start position (PFU))
When PFP is installed:
05-4018-2 (PFP upper drawer sideways deviation (for the field adjustment))
05-4018-3 (PFP lower drawer sideways deviation (for the field adjustment))
05-4060 (Adjustment of secondary scanning laser writing start position (PFP))
When ADU is installed:
05-4062 (Adjustment of secondary scanning laser writing start position (ADU))
05-4019-0 (Adjustment of primary scanning data laser writing start position at duplexing (long
size))
When RADF is installed:
05-3042 (Fine adjustment of the RADF transport speed)
05-3043 (RADF sideways deviation adjustment)
05-3044 (RADF leading edge position adjustment)
05-3045 (RADF leading edge position adjustment)
05-3046 (Adjustment of the position of the carriage when scanning from the RADF (in black
mode))
05-3047 (Adjustment of the position of the carriage when scanning from the RADF (in color
mode))
Also, set the adjustment values which have been changed for servicing.
(13) Perform 05-7165/7167 (Automatic gamma adjustment).
(14) When RADF is installed, perform 05-3050/3051 (Adjustment of the RADF tray volume).
(15) Turn the power OFF and then start with the setting mode (08).
(16) Set the setting value.
Set the setting values of the following codes according to the list printed out in advance.
(If the adjustment values could not be printed out because of the Flash memory damage or any
other reason, enter the values on the list output at the time of the last maintenance. If there is no
list, enter the default values.)
When RADF is installed:
08-6382-0 (Pickup roller (RADF) (Current number of sheets printed))
08-6382-1 (Pickup roller (RADF) (Recommended replacement period (No. of sheets printed))
08-6382-2 (Pickup roller (RADF) (No. of sheets printed last time))
08-6382-8 (Pickup roller (RADF) (No. of times it was replaced))
08-6384-0 (Paper feed roller (RADF) (Current number of sheets printed))
08-6384-1 (Paper feed roller (RADF) (Recommended replacement period (No. of sheets
printed))
08-6384-2 (Paper feed roller (RADF) (No. of sheets printed last time))
08-6384-8 (Paper feed roller (RADF) (No. of times it was replaced))
08-6386-0 (Separation roller (RADF) (Current number of sheets printed))
08-6386-1 (Separation roller (RADF) (Recommended replacement period (No. of sheets
printed))
08-6386-2 (Separation roller (RADF) (No. of sheets printed last time))
08-6386-8 (Separation roller (RADF) (No. of times it was replaced))
(17) Check that the setting value for 08-9010 is "0". If it is "1", change it to "0".
(18) Start the equipment in the normal mode and set the time and date.
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
9 - 11
REPLACEMENT OF PC BOARDS
9