4.7.18
Developer unit
Notes:
•
Make sure to perform "05-2390" and take
off the process unit before the developer
material is replaced
•
The developer units of 20L/23L/25L/20H/
23H/25H and 23LA/23LM/28LM/23HA/
28HA are different from each other. You
can distinguish them by color of gear.
-
20L/23L/25L/20H/23H/25H: White
-
23LA/23LM/28LM/23HA/28HA: Gray
(1)
Take off the process unit.
P. 4-49 "4.7.1 Process unit <20L/23L/25L/
20H/23H/25H>"
P. 4-50 "4.7.2 Process unit <23LA/23LM/
28LM/23HA/28HA>"
(2)
Take out the drum cleaner unit [1] from the
process unit so that only the developer unit
[2] will be left in it
P. 4-51 "4.7.3 Drum cleaner unit"
Notes:
1. Be careful not to touch or scratch the
drum surface.
2. Avoid direct light. Place the drum in a
dark place immediately after taking off.
3. Place the removed drum cleaner unit
facing the direction shown in the figure.
4.7.19
Removing developer material
(1)
Take off the developer unit.
P. 4-59 "4.7.18 Developer unit"
(2)
Release 2 latches and then take off the
developer unit upper cover [1].
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
<20L/23L/25L/20H/23H/25H>
Fig. 4-152
[1]
Fig. 4-153
[1]
Fig. 4-154
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
4 - 59
<23LA/23LM/28LM/23HA/28HA>
[2]
DISASSEMBLY AND REPLACEMENT
4