Cleaning Unit/ Developer Unit - Toshiba e-STUDIO2330C Service Manual

12.6.3

Cleaning unit/ Developer unit

[A] Cleaning unit/ Developer unit
(1) Take off the process cover.
 P.12-13 "12.6.2 Process cover"
(2) Remove 2 screws and take off the front
retainer.
Note:
Be sure not to lose the bearing installed on
the front retainer.
(3) Release 1 latch on the rear side of the
developer unit to open the cleaner unit in the
direction of the arrow. Slide the cleaning unit
to the rear side to separate it from the
developer unit.
Notes:
• Be sure not to touch, spit or scratch on
the drum surface.
• Avoid a direct sunlight onto the drum.
Move it to a dark place as soon as it is
taken off.
12.6.4 Main charger assembly
(1) Take off the cleaning unit.
 P.12-15 "[A] Cleaning unit/ Developer
unit"
(2) Hold (A) part on the front side of the main
charger assembly, lift the cleaner case up
and take off the main charger assembly.
Notes:
• Be sure not to touch, spit or scratch on
the drum surface.
• Avoid a direct sunlight onto the drum.
Move it to a dark place as soon as it is
taken off.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Front retainer
Fig. 12-17
Cleaning Unit
Developer unit
Fig. 12-18
Cleaner case
Main charger assembly
Fig. 12-19
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
12 - 15
Bearing
Latch
A
PROCESS UNIT RELATED SECTION
12