Version (Rip) - Allied Telesis AT-AR3050S Command Reference Manual

RIP C
OMMANDS
(RIP)
VERSION

version (RIP)

Overview Use this command to specify a RIP version used globally by the router.
Use the no variant of this command to restore the default version.
Syntax version {1|2}
no version
Default Version 2
Mode RIP Router Configuration
Usage RIP can be run in version 1 or version 2 mode. Version 2 has more features than
version 1; in particular RIP version 2 supports authentication and classless routing.
Once the RIP version is set, RIP packets of that version will be received and sent on
all the RIP-enabled interfaces.
Setting the version command has no impact on receiving updates, only on
sending them. The
version (RIP)
command allows you to configure a specific interface to accept only packets of the
specified RIP version. The
version
Examples To specify a RIP version, use the following commands:
awplus#
awplus(config)#
awplus(config-router)#
Validation
Commands
show running-config
Related ip rip receive version
Commands
ip rip send version
C613-50077-01 REV A
Parameter Description
1|2
Specifies the version of RIP processing.
ip rip send version
command on an interface-specific basis. The
command override the value set by this command.
configure terminal
router rip
awplus#show running-config

!
router rip
version 1
!
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
command overrides the value set by the
ip rip receive version command and the
version 1
ip rip receive version
ip rip send
708