Table 101: Mx960 High-Capacity Dc Power Supply Leds - Juniper MX960 Hardware Manual

3d universal edge router
Hide thumbs Also See for MX960:
Table of Contents

Advertisement

Table 101: MX960 High-Capacity DC Power Supply LEDs

Connected Inputs
INP0 connected, INP1 disconnected
INP0 disconnected, INP1 connected
INP0 connected, INP1 connected
Copyright © 2017, Juniper Networks, Inc.
CAUTION:
The maximum torque rating of the terminal studs on the DC
power supply is 36 lb-in. (4.0 Nm). The terminal studs may be damaged
if excessive torque is applied. Use only a torque-controlled driver or socket
wrench to tighten nuts on the DC power supply terminal studs.
NOTE:
The DC power supplies in slots
by dedicated power feeds derived from feed
in
and
PEM2
from feed
. This configuration provides the commonly deployed
B
redundancy for the system. For information about connecting to DC power
sources, see
on page
169.
Verify that the power cabling is correct, that the cables are not touching, and that they
12.
do not block access to router components or drape where people could trip on them.
Replace the clear plastic cover over the terminal studs on the faceplate.
13.
Switch on the dedicated customer site circuit breaker.
14.
Verify that the
INPUT 0 OK
15.
steadily. If using two feeds, verify that both
power supply are lit steadily. The
in reverse polarity. Check the polarity of the power cables to fix the condition (see
Figure 75 on page 240
and
Move the switch to the on (
16.
Verify that the
DC OK
LED is lit green steadily. See
17.
on MX960 high-capacity DC LEDs.
LEDs
DIP
Switch
Position
INP-0 OK
0 (1
Green
input)
Off
Green
Chapter 30: Converting to a Different Type of Power Supply
must be powered by dedicated power feeds derived
PEM3
"Electrical Specifications for the MX960 DC Power Supply"
or
INPUT 1 OK
LEDs on the power supply are lit green
INPUT 0 OK
will be lit amber if that input's voltage is
INPUT OK
Table 99 on page
239.
|
) position.
Table 99 on page 239
INP-1 OK
Off
Green
Green
and
must be powered
PEM0
PEM1
A
, and the DC power supplies
and
LEDs on the
INPUT 1 OK
for information
DC OK
PS FAIL
Green
Off
Green
Off
Green
Off
feed
A/B
477

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mx960 3d

Table of Contents