Ptx1000 Management Port Leds; Figure 10: Ptx1000 Management Panel Components - Juniper PTX1000 Hardware Manual

PTX1000 Management Port LEDs

Copyright © 2018, Juniper Networks, Inc.

Figure 10: PTX1000 Management Panel Components

1— RJ-45 (1000BASE-T) management
Ethernet port (labeled MGMT
OS CLI, this port is identified as
2— CON
RJ-45 console port (
RS-232 serial ports.
3— Reset button. Press and hold 5 seconds to
reset the hardware. Clock functions and
FPGA status registers are not reset.
4— PWR
Status LEDs—Power (
major alarm ( MAJ ), and minor alarm (
5—SFP management Ethernet port (labeled
MGMT ). In the Junos OS CLI, this port is
em1
identified as .
There are two management ports on the PTX1000, located on the management panel
next to the network ports. Both ports are labeled
is for 10/100/1000BASE-T connections and the small form-factor pluggable (SFP)
management port is for 10/100/1000BASE-T and 1000BASE-X connections.
The RJ-45 port has separate LEDs for status and activity. The SFP port has a LED to
indicate both link and activity.
6— SFP PTP Ethernet (1000BASE-T) port
). In the Junos (labeled
em0
.
7—
) to support 10 Hz pulses-per-second (
SubMiniature B (SMB) connector for input
and output measuring of the timing drift to
and from a grandmaster clock. Port reserved
for future use.
8—
10 MHz SMB timing connector (
Port reserved for future use.
STS 9— USB port.
), status ( ),
MIN ).
MGMT
Figure 11 on page 32 shows the location of the LEDs.
Chapter 1: Overview
ETH ). Port reserved for future use.
PPS
)
10MHz
. The RJ-45 management port
).
31