Honda ACCORD HYBRID 2005 Service Manual page 1159

<3®
S e c o n d a r y S h a f t I n s t a l l a t i o n H e i g h t I n s p e c t i o n / A d j u s t m e n t
1. Install the thrust needle bearing (A) in the torque 3. Measure the height (B) of the secondary shaft
converter housing (B) in the direction s h o w n , and installation between the surface (C) of the gasket
install the secondary shaft assembly (C). and the t o p of the ball bearing outer race (D), then
2. Install the new gasket (A) on the torque converter
housing.
(cont'd)
14-323