Honda ACCORD HYBRID 2005 Service Manual page 1135

R e g u l a t o r V a l v e B o d y D i s a s s e m b l y , I n s p e c t i o n , a n d R e a s s e m b l y
1. Clean all parts t h o r o u g h l y in solvent or carburetor cleaner, and dry t h e m w i t h compressed air. Blow out all
passages.
2. Inspect the regulator valve body for scoring and damage.
3. Hold the regulator spring cap in place w h i l e r e m o v i n g the stop bolt. The regulator spring cap is spring loaded.
Once the stop bolt is r e m o v e d , release the spring cap slowly so it does not pop out.
4. Check all valves for free m o v e m e n t . If any fail to slide freely, refer to valve body repair (see page 14-294).
5. Coat all parts w i t h ATF during assembly.
6. A l i g n the hole in the regulator spring cap w i t h the stop bolt hole, then press the spring cap into the valve body,
and tighten the stop bolt.
7. Install the servo valve w i t h the new O-ring, and the 3rd accumulator piston w i t h the new O-ring.
V A L V E SPRING SPECIFICATIONS
Valve Springs Standard (New)-Unit: mm (in.)
Wire Diameter O.D. Free Length No. of Coil
A 3rd accumulator spring 3.1 (0.122) 19.6(0.772) 41.4(1.630) 5.5
B Lock-up control valve spring 0.7 (0.028) 6.6 (0.260) 42.9(1.689) 14.2
C Regulator valve spring B 1.4(0.055) 8.8 (0.346) 44.0 (1.732) 12.0
D Regulator valve spring A 1.9 (0.075) 14.7 (0.579) 80.6(3.173) 16.1
E Stator reaction spring 5.5 (0.217) 37.4 (1.472) 30.3(1.193) 2.1
14-299