Honda ACCORD HYBRID 2005 Service Manual page 1150

Shafts and Clutches
C o u n t e r s h a f t R e a s s e m b l y
Special Tools Required
Driver, 40 m m I. D. 07746-0030100
1. Install the 2nd gear (A), thrust needle bearing (B),
needle bearing (C), idler gear (D), thrust needle
bearing (E), 56 m m washer (F), 1st gear (G), 4th
gear (H), 50.2 m m washer (I), 39 m m cotters (J),
cotter retainer (K), and snap ring (L) on the
countershaft (M).
2. Install the 35 x 47 x 6 m m thrust washer (N) in the
direction s h o w n , then install the needle bearing (O)
and the 5th gear (P).
3. Slide the reverse selector hub (A) over the
countershaft (B), then press it into place w i t h the
special tool and a press.
NOTE: Some reverse selector hubs are not press-
fitted, and can be installed w i t h o u t using the
special tool and a press.
B
4. Install the reverse selector, reverse gear collar,
needle bearing, and reverse gear over the reverse
selector hub.
14-314