Hitachi Compute Blade 500 Series User Manual page 304

No.
(6)
(7)
(8)
(9)
(10)
7-100
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Item
USB Auto Specifies whether USB Auto Attach is
Allocation to enabled or
LPAR
disabled.
Enable: A USB device is automatically
attached when the LPAR is activated.
Disable: A USB device is automatically
attached only to specified LPARs.
Save Set the Automatic Configuration Save
function either enabled or disable,
Changed
Set whether or not an LPAR manager
Config
configuration is saved automatically in
Format
the following situations.
- After a format for an LPAR manager
configuration is changed automatically
when the LPAR manager boots.
- When an LPAR manager configuration
is not saved and you shut down the
LPAR manager.
Enable: An LPAR manager configuration
is saved automatically.
Disable: An LPAR manager configuration
is not saved automatically.
LP Sets a value for timer counter
TimerCounter calculation.
Base
TSC : Based on TSC (default).
Cpu Frequency : Based on CPU
frequency.
LP TimerCounter Base is displayed when
the timer precision of "TSC" is lower
during operation, you can select "TSC"
or "Cpu Frequency". Select the smaller
one for time-lag. LP TimerCounter Base
is not displayed when the timer
precision of "TSC" is higher, "TSC" is
operated.
Save Time Sets whether or not to automatically
save adjusted time configuration of
Config
LPAR manager system time and LPAR
time in physical RTC and LPAR manager
configuration information.
Enable: Enables the Save Time Config.
Disable: Disables the Save Time Config.
Safe Mode Displays whether the safe mode is on.
Cancels safe mode.
ON: Safe mode
Operation by LPAR manager Screen
Description
Supported
Default LPAR
Value manager
Version
Enable 01-0X~
Disable 01-0X~
TSC 01-3X~
Disable 01-6X~
OFF 02-1X~