Hitachi Compute Blade 500 Series User Manual page 307
Logical partitioning manager
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (506 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
When there is LPAR which specifies the memory node (by MN field) in
Logical Partition Configuration screen, activations of the LPARs which
specify the memory node are performed first.
If for any reason (such as a failure to obtain the allocated memory) the
Auto Activation of any LPAR fails, the subsequent LPARs will not be Auto
Activated.
For 15 seconds before the Auto Activation starts, the system will accept
cancellation of the processing. To cancel the Auto Activation, press [Ctrl]
+ [c]. Once the Auto Activation has started, it cannot be canceled.
How to change Pre-State Auto Activation
Place the cursor on "Pre-State Auto Activation" under "System Control" and
press [Enter] to display a sub-screen. Use the up and down arrow keys to
select 'Yes' or 'No', and press [Enter].
How to change LP Auto Shutdown
Place the cursor on "LP Auto Shutdown" under "System Control" and press
[Enter] to display a sub-screen. Use the up and down arrow keys to move the
cursor to select 'Yes' or 'No', and press [Enter].
Note:
•
If using Power Off Function of UPS, set "LP Auto Shutdown" to 'Yes'
•
When LPAR migration is performed, LP Auto Shutdown is disabled, the
same as when the value is "No".
How to cancel shutdown processing due to the power control
schedule
When the LPAR manager system is shut down using the power control
schedule of ServerConductor / Blade Server Manager, the shutdown state
changes from Ready to In Progress when the shutdown time arrives, and
shutdown processing begins.
At this time, operations to activate LPARs are suppressed. To cancel this
shutdown processing, follow the steps below.
Place the cursor on "Shutdown State" under "System Control" and press
[Enter] to display a sub-screen. Use the up and down arrow keys to select
'Yes', and press [Enter].
If all the LPARs are not deactivated within 30 minutes from the start of
shutdown processing, the shutdown processing is canceled and the shutdown
status returns to Ready. This also removes the suppression of LPAR
activation.
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
7-103
Advertisement
Table of Contents
