Hitachi Compute Blade 500 Series User Manual page 244

No.
The following table describes each item on this screen.
Item
Name
Sta
PCI Device#
Type
Schd
PCI Device
Assignment
Legend:
Y: Can be changed
N: Cannot be changed
C: Can be changed only in dedicated mode.
How to change Scheduling Mode (Schd)
You can change the Scheduling Mode (Schd) of a NIC or FC that support
shared allocation. "+" is added to the scheduling mode (Schd) of the PCI
device that can be configured.
Before modifying the Schd setting of a NIC or FC, you must deactivate all
LPARs. Move the cursor to the intersection between the Schd row and the PCI
device number column, and press [Enter]. This opens a sub-screen where
you can select assignments.
Move the cursor over the item that you want to change, and press [Enter]. To
apply the changes of Schd to the LPAR manager system, press [F10] and
select "Yes" in the confirmation sub-screen that opens. After you select "Yes",
7-40
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Item
Note: Operation with [F10] (Update PCI
Dev Schd) should be done when no LPAR is
activated. If you do with any LPAR in
activation, network communication of the
LPAR is disconnected for a few minutes.
SC/BSM displays Deactivate as LPAR
manager status, and no error message is
provided.
Table 7-15 LPAR Status on the PCI Devices Assigned Screen
LPAR Status
Activate Deactivate
N N
N N
N N
N N
N Y
N C
Operation by LPAR manager Screen
Description
Failure
N
N
N
N
N
N
Supported
Default LPAR
Value manager
Version
Supported
LPAR
Remark
manager
Version
Display Only 01-0X~
Display Only 01-0X~
Display Only 01-0X~
Display Only 01-0X~
- 01-0X~
- 01-0X~