Common Items For All Screens; Lpar Manager Menu - Hitachi Compute Blade 500 Series User Manual

• Execute operation ([alt]+t) for refreshing screen when following
phenomenon occurred.
– Previous display remains on the screen.
– A part of display lacks on the screen.
– A cursor cannot move by pressing arrow keys though selectable items
exist on the screen.
– A cursor is not displayed though selectable items exist on the screen.
• LPAR manager screen might be switched when any arrow key or any
function key is consecutively pressed. Re-display a target screen if this
phenomenon occurred.
• LPAR manager screen cannot be operated for one or two minutes while a
lot of LPARs are being activated or deactivated by operating SC/BSM.

Common items for all screens

Common items for all screens are below.
Figure 7-1 LPAR manager Status on the LPAR manager Screen
No.
(1)
(2)

LPAR manager Menu

LPAR manager Menu screen is below.
7-6
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Table 7-3 Description of Error Event Detection
Item
Error Event It indicates that error was
Detected detected in LP System Logs.
Please confirm the LP System
Logs on the LP system logs
screen when this item is
displayed.
This item disappears on the
screen by pressing [Esc] key or
opening LP system logs screen
again.
Safe Mode It indicates that LPAR manager
started in the safe mode.
Confirm the NIC allocation to
LPARs, change the setting of
allocation to LPARs if required,
and then release the safe
mode.
Operation by LPAR manager Screen
Description
Supported LPAR
Default
manager
Value
Version
- 01-0X~
- 02-1X~