Hitachi Compute Blade 500 Series User Manual page 311

Figure 7-78 Saving "LP Timercounter Base" and reboot screen
How to change the setting for Save Time Config
[LPAR manager firmware version 01-6X or later]
Note:
• With LPAR manager firmware version 01-6X or later, enabling "Save Time
Config" is recommended. If you reboot LPAR manager after operating it
for a long time with "Save Time Config" disabled, or if a system failure in
LPAR manager or failover with N+M cold standby unexpectedly occurs, a
time lag occurs in the guest OS.
• You can change settings for "Save Time Config" while LPAR manager is
running.
• If changing LPAR manager configuration or LPAR configuration with "Save
Time Config" enabled, make sure to save LPAR manager configuration at
the end of the setting change. Although LPAR manager configuration is
saved at time adjustment with "Save Time Config" enabled, the timing
cannot be specified.
• When LPAR manager configuration is saved at time adjustment, LPAR
manager screen appears; system event logs are collected; the alert is
notified. Those operations can be prevented by disabling "Save Time
Config".
[LPAR manager screen]
[System event log]
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
7-107