Hitachi Compute Blade 500 Series User Manual page 271
Logical partitioning manager
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (506 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
Note:
•
Operation with [F10]: Update System Config is not required to reflect a
setting change. It may take about 10 seconds to reflect a setting change.
How to set the VNIC System No.
Place the cursor on the VNIC System No. and press [Enter] to display a sub-
screen. Enter the new virtual NIC Setting Number on the sub-screen and
press [Enter].The initial setting of the VNIC System No. is 0. Set the new
value except 0 at the first LPAR manager boot. Otherwise, the LPAR manager
system will not boot.
You can change the VNIC System No. only when all LPARs are deactivated.
LPAR manager does not check if the entered value is used for another LPAR
manager system.
Note:
•
A VNIC System No. is used for creating a unique MAC address to a Logical
NIC. Thus, set a unique value to all LPAR manager system such as
Compute Blade Series.
•
Do not change the VNIC system No., otherwise the following phenomena
might occur.
– The MAC address of the Logical NIC assigned to the guest OS on LPAR
manager will change.
– When reusing VNIC System No. which was used on other LPAR
manager, MAC address of Logical NIC might overlap with others.
How to set the Alert Language
Place the cursor on the Alert Language and press [Enter] to display a sub-
screen. Select a language to use on the sub-screen and press [Enter].
How to set the Virtual Console Port
Place the cursor on Virtual Console Port and press the [Enter] key to display a
sub-screen. Input a virtual console port that you want to change, and then
press the [Enter] key.
When changing the virtual console port value, the TCP port is changed.
Therefore, reconnecting the LPAR guest screen is necessary.
If the changed value of the virtual console port is the same as the TCP port
used in another application, you may not be able to access the LPAR guest
console.
How to set LP CLI IP Address
Place the cursor on LP CLI IP Address, and press the [Enter] key to display a
sub-screen. Type an LP CLI IP address you want to change and press the
[Enter] key.
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
7-67
Advertisement
Table of Contents
