Hitachi Compute Blade 500 Series User Manual page 369

Message Content
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP dump management file access error occurred.
File access error of LPAR manager dump management occurred.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP dump transfer failed.
Transfer of the LPAR manager dump to the management module
failed.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP failed deletion of the initial parameter file.
Deleting the initial parameter file failed.
If this LP System Logs is often collected, contact your reseller or
consult maintenance personnel.
LP failed in network time synchronization by NTP.
Synchronization the LPAR manager system time by NTP failed.
Check the followings.
Whether specified IP Address is correct.
Whether NTP Server is operating.
Whether LAN route is connecting to NTP Server.
LP Loader deleted the initial parameter.
LPAR manager detected the initial parameter file (InitParam.dat)
and deleted it.
The initial parameter file is deleted due to the following reasons,
which are divided by LP System Logs detailed messages.
- Restore is performed with Web console, CLI console.
- Initialization is performed with Web console, CLI console.
- Cloning is performed with BSM.
- N+M cold standby is performed.
- Discrepancy between blade serial numbers.
Messages
LP dump is lost.
9-35