Hitachi Compute Blade 500 Series User Manual page 138

2 Configure settings for automatically saving time information.
.
[LPAR manager firmware version 01-6X or later]
Note:
•
•
•
•
– Go to the Options screen.
– On the Options screen, place the cursor on "Save Time Config" and
press [Enter] to display the sub-screen. Select [Enable] and press
[Enter].
3 Save the setting on the LPAR manager screen.
.
– Move to the LPAR manager Menu Screen.
– Press [F9] (Save Configuration) key on the LPAR manager Menu screen.
5-8
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
With LPAR manager firmware version 01-6X or later, enabling "Save
Time Config" is recommended. If you reboot LPAR manager after
operating it for a long time with "Save Time Config" disabled, or if a
system failure in LPAR manager or failover with N+M cold standby
unexpectedly occurs, a time lag occurs in the guest OS.
You can change settings for "Save Time Config" while LPAR manager
is running.
If changing LPAR manager configuration or LPAR configuration with
"Save Time Config" enabled, make sure to save LPAR manager
configuration at the end of the setting change. Although LPAR
manager configuration is saved at time adjustment with "Save Time
Config" enabled, the timing cannot be specified.
When LPAR manager configuration is saved at time adjustment, LPAR
manager screen appears; system event logs are collected; the alert is
notified. Those operations can be prevented by disabling "Save Time
Config".
[LPAR manager screen]
[System event log]
[Alert]
ID: 0x1531
Message: LP configuration was saved. (RC=6)
Setup of LPAR manager
Figure 5-9 Options screen