Hitachi Compute Blade 500 Series User Manual page 370

Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
9-36
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
LP Loader detected load error and recovered.
Configuration information failed to be read; however, this error
was corrected.
If this LP System Logs is obtained each time LPAR manager
starts, contact the reseller from which you purchased this
equipment or consult maintenance personnel.
LP started retrying the setting of TxRate configuration.
LPAR manager starts to retry the setting of TxRate configuration,
due to the setting failure.
Wait for a while.
LP System Shutdown Failed.
Failed to shutdown the LPAR manager system.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP-LFW detected failure of getting boot device.
LPAR manager logical firmware detected a failure to get boot
device.
Contact your reseller or maintenance personnel.
LP-LFW detected failure of setting boot order.
LPAR manager logical firmware detected a failure to set a boot
order.
Check and fix the boot order setting file. If it does not work,
contact your reseller or maintenance personnel.
LP-LFW detected internal error.
LPAR manager logical firmware detected an internal error but it
recovered.
If this LP System Logs is often collected, contact your reseller or
maintenance personnel.
LP-LFW detected tftp error.
LPAR manager logical firmware detected the network failure at
the time of network boot.
Reset a network load situation and execute network boot again. If
the system log is still taken after executing again. Contact the
reseller from which you purchased this equipment or consult
maintenance personnel.
Messages