System Service State - Hitachi Compute Blade 500 Series User Manual

Place the cursor on the user displayed for [Name] in [User List], and then
press [F2] (Remove). On the displayed sub-screen, select [Yes], and then
press [Enter]. After the setting is complete, configuration information for user
authentication is stored automatically.
How to change the password
[LPAR manager firmware version 02-05 or later]
Place the cursor on the user displayed for [Name] in [User List], and then
press [F3] (PW Change). On the displayed sub-screen, enter the password,
and then press [Enter]. Then, re-enter the password, and then press [Enter].
After the setting is complete, configuration information for user
authentication is stored automatically.
• You can use alphanumeric characters and symbols (other than spaces) for
the password.
You can use 1 to 31 characters for the password.

System Service State

The following functions are available in the [System Service State] screen.
Example of System Service State screen is below.
7-70
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Figure 7-30 LPAR manager System Service Status Screen
Operation by LPAR manager Screen