•
Place the cursor on Setting on the Date and Time screen and press
[Enter] to display a sub-screen. Select "Setting" and press [Enter].
•
Place the cursor on TimeSynch on the Date and Time screen and press
[Enter] to display a sub-screen. Select "SVP" and press [Enter].
•
Check that NTP is set to SYNC on the System Service State screen.
•
Adjust the time of LPAR using Adjust LPAR Time on the Date and Time
screen.
7-90
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Figure 7-48 Change of the Time zone
Figure 7-49 Setting the NTP Config
Figure 7-50 Setting of the SVP
Figure 7-51 Checking the System Service State
Operation by LPAR manager Screen