Warn Level - Hitachi Compute Blade 500 Series User Manual

Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do

Warn Level

Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
9-32
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
There are not enough H/W resources for SR-IOV feature.
Shortage of H/W resources for SR-IOV feature was detected.
Confirm whether the firmware combinations are proper, as the
version supporting the SR-IOV function.
For details of combination, see the Hitachi Compute Blade Emulex
Adapter User's Guide for Hardware.
VNIC damage occurred.
A virtual NIC fault occurred.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
VNIC damage on LP Assist occurred.
A virtual NIC (LPAR manager Assist) fault occurred.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Guest dump failed.
Guest memory dump failed.
To get the information on the failure and its factors, execute the
command "Get guest memory dump progress" of HVM
management command (HvmSh command). Deal with the
problem according to "Status Codes and Messages" displayed by
this command.
H/W Corrected MCK occurred.
A corrected machine check event occurred.
None.
LP changed Management Path and LPAR configuration was
A NIC set in the dedicated mode is specified as the management
NIC; therefore, the scheduling mode of the NIC was changed
from the dedicated mode to the shared mode. Dedicated
allocation of the NIC to LPARs was released.
LPAR manager has shifted to the safe mode. Confirm the NIC
allocation to LPARs, change the setting of allocation to LPARs if
required, and then release the safe mode.
Messages
changed.