Hitachi Compute Blade 500 Series User Manual page 291

How to change the NTP configuration display
Place the cursor on Setting or NTP at the lower left side and press [Enter] to
display a sub-screen for selecting the NTP configuration. Place the cursor on
the item to display and press [Enter].
How to import the NTP configuration
Note:
• Check that there are no problems with Automatic Time Synchronization to
be imported before importing from the management module or BMC.
• When import source of NTP configuration is set to the management
module, only the setting value of NTP server 1 and 2 are imported to the
LPAR manager. (The setting value of NTP server 2 and 3 are ignored.)
• Only Hour part of TimeZone which was imported from the NTP server is
valid on the LPAR manager. (Minutes part is ignored on the LPAR
manager)
• Not supporting summer time configuration.
Date and time screen is displayed below after the LPAR manager imported
NTP configuration from the management module.
Manage-ment Automatic Time
module time Synchronization
setting
BMC Time
time Synchronization
setting Method
• Place the cursor on Import Config at the lower left side and press [Enter]
to display a sub-screen. Place the cursor on the item to import and press
[Enter].
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Table 7-32 Date and Time Screen Information
Item
Enable
Disable
Synchronize time with
the Management-
Modules by using NTP.
Synchronize time with
the Management-
Modules by command or
manual.
Operation by LPAR manager Screen
Date and Time screen
Import Time NTP
Config Sync Server 1
SVP NTP NTP
Server 0
SVP Disable NTP
Server 0
BMC SVP None
BMC Disable None
NTP
Server
2
NTP
Server 1
NTP
Server 1
None
None
7-87