Hitachi Compute Blade 500 Series User Manual page 245

you will not be able to perform any operations on LPAR manager for two or
three minutes until the setting changes completes.
To abort the change of Schd, press [F10] and select "No" in the confirmation
screen that opens. All changed settings are restored to their original values.
Since the time necessary to the change becomes enable for an LPAR manager
system. You cannot change except the Schd or move to other screens until
finish the change process. To change except the Schd or move to other
screens, press [F10], select either "Yes" or "No" and conclude the change
process, or cancel it.
How to assign a PCI device to an LPAR
Move the cursor over the intersection between the LPAR, to which you want
to assign the PCI device, and the PCI device column, and press [Enter]. In
the sub-screen that appears, move the cursor over [A] and press [Enter]. To
undo an assignment, select "*"
How to change a using direction of PCI device
Press [F5] (Attach/Detach) to display a sub-screen, select LPAR of changing
and press [Enter].
How to change USB Auto Attach settings
Note:
• Make sure to disable USB Auto Allocation to LPAR in the LP Options screen
before using this function.
• When you activate an LPAR with #A for the USB assignment, the state is
changed to #R. If the USB has been attached to another LPAR, Auto
Attach/Detach will not be performed.
• When you have a USB device state unassigned, the Auto Attach setting is
cancelled.
USB Auto Attach settings can be changed with a LPAR activated or
deactivated.
When you place the cursor on A or R for USB assignment status and press
[F6] (Set/Reset), the status is switched between Set and Reset. Since this
setting is exclusive, the setting will move to another LPAR if the USB device is
assigned to the LPAR.
When Set is specified, A or R shown on the screen will be changed to #A or
#R, while attaching /detaching the USB device is not performed.
When Reset is specified, #A or #R shown on the screen will be changed to A
or R, while attaching /detaching the USB device is not performed.
USB Auto Attach is performed only with LPARs with #A for USB allocation
status when the LPAR is activated. If USB allocation status is not #A, USB
Auto Attach cannot be performed. If with no #A LPAR, USB Auto Attach will
not be performed for any LPAR.
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
7-41