Hitachi Compute Blade 500 Series User Manual page 104

*SVP: Management module
The data taken over to the standby server blade from the active server blade
under an N+M cold standby environment and the attention items when the
environment is configured are as follows.
Table 3-2 Data taken over to the Standby Server Blade and Attention Item
EFI settings
Management Module
settings
LPAR manager Boot
Information
3-4
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Figure 3-1 Outline N+M Cold Standby
Item Description
EFI settings for LP mode
Operational mode for
physical server blade
(Basic / LPAR manager)
LP IP Address
Subnet Mask
VNIC System No.
Time Zone
Optional Physical MAC
address
Logical NVRAM information
(Boot Order, EFI Driver
Configuration)
High Reliability Functions
Attention for N+M cold
Transfer standby configuration
environment
Yes It is unnecessary to set
to a standby server blade
Yes
the information written
to left-hand side.
1 It is necessary to set
Yes
beforehand to a standby
1
Yes server blade the
information written to
2
Yes
left-hand side.
2
Yes
1 It is unnecessary to set
Yes
to a standby server blade
the information written
Yes
to left-hand side.