Hitachi Compute Blade 500 Series User Manual page 309

Configuration information auto save functionality
No.
(3) Sends an alert notification about saving of the configuration
information by pressing [F9] when [F9] is pressed.
If you move the cursor to "Save Changed Config Format", and then press
[Enter], a sub-screen appears. Select "Enable" or "Disable", and then press
[Enter].
How to change the "LP Timercounter Base" and raise the accuracy
of LPAR manager system time (when not using NTP)
[LPAR manager firmware version 01-3X or later]
Tip:
• LP TimerCounter Base is displayed when the timer precision of "TSC" is
lower during operation, you can select "TSC" or "Cpu Frequency". Select
the smaller one for time-lag. LP TimerCounter Base is not displayed when
the timer precision of "TSC" is higher, "TSC" is operated.
It is necessary to deactivate all LPARs for changing "LP Timercounter Base".
• Place the cursor on "LP Timercounter Base", and press [Enter].
Figure 7-75 To change "LP Timercounter Base" on "LP Options"
• Select TSC or Cpu Frequency on the sub-screen, and press [Enter].
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Disable
screen
Supported
version
Enable
01-0X or
later
7-105