Hitachi Compute Blade 500 Series User Manual page 272
Logical partitioning manager
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (506 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
Do not set a multicast address and broadcast address.
Note:
•
Operation with [F10]: Update System Config is not required to reflect a
setting change. It may take about 10 seconds to reflect a setting change.
How to apply the changes to the LPAR manager system
Operations using [F10] (Update System Config) are not available on the
second page of the System Configuration screen.
To apply all the changes made in the [System Configuration] screen to the
LPAR manager system, press [F10]: Update System Config and select "Yes"
in the confirmation sub-screen that opens.
After selecting "Yes", you will not be able to perform any operations on LPAR
manager for a couple of minutes.
To cancel the changes, press [F10]: Update System Config and select "No" in
the confirmation screen that opens. All changed settings will be restored to
their original values.
Because it takes time for the changed settings to be reflected in the LPAR
manager system, the movement to another screen is not allowed before the
reflection has finished completely. If you go to another screen, press [F10]:
Update System Config and select "Yes" to complete the reflection, or select
"No" to cancel the changes.
Note:
•
Operation with [F10] (Update system Config) provides a temporary
change in the screen when LPAR manager is running. Thus, the setting,
which is not saved, will disappear when LPAR manager is rebooted.
Execute [F9] (Save configuration) in the LPAR manager Menu screen to
save the new setting.
•
If you change a BSM IP address, BSM alert port, or Alert language in this
screen, the setting values are effective only during LPAR manager running
and not saved with [F9] (Save Configuration). When you reboot LPAR
manager, the value set in the management module will become the initial
value.
How to perform user authentication for virtual COM connections
[LPAR manager firmware version 02-05 or later]
Place the cursor on [VC], and then press [Enter]. On the displayed sub-
screen, select [Enable], and then press [Enter]. After the setting is complete,
configuration information for user authentication is stored automatically.
How to perform user authentication for LP CLI connections
[LPAR manager firmware version 02-05 or later]
7-68
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Operation by LPAR manager Screen
Advertisement
Table of Contents
