Hitachi Compute Blade 500 Series User Manual page 266

No.
(9)
(10)
(11)
(12)
(13)
7-62
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Item
management path settings. For the
firmware combination details, see
"Firmware
VNIC System Sets a value that is not identical to the
No other LPAR manager systems, including
Compute Blade Series.
Table VNIC System No shows the range
of numbers that VNIC System No can be
set.
This value is used as part of the Logical
NICs MAC address.
Without setting this number, you cannot
go to another screen.
Alert Sets the language used in the alert
Language messages.
When LPAR manager is started, the
Language Mode that has been set to the
management module will be applied as
the initial value. (Recommended setting)
Japanese: Displays the alert message in
Japanese.
English: Displays the alert message in
English.
Virtual Set the TCP port to connect the guest
Console Port console via Telnet or SSH.
However, if the virtual COM connection
method is "Telnet for which user
authentication is enabled" or "ssh", the
values that can be set are 1024 to
65504.
Can set only a TCP port that is connected
to VC1.
One is added to the TCP number of VC2
and consecutive TCPs as one is added to
the number of VC.
When booting LPAR manager, the TCP
ports (serial numbers starting from
20801) that LPAR manager obtains are
reflected by default: this setting is
recommended.
LP CLI1~8 Sets LP CLI IP Address.
IP Address Sets the IP address of a server where
commands such as HvmSh and
HVMGetPerf work.
Function Key Displays the function keys that can be
used in this screen.
Operation by LPAR manager Screen
Description
combinations"
Supported
Default LPAR
Value manager
Version
0 01-0X~
- 01-0X~
20801 01-0X~
0.0.0.0 01-0X~
- 01-0X~