Efi Driver Setting Items - Hitachi Compute Blade 500 Series User Manual

item
LPAR manager Scheduling
Screen Mode(Schd)
PCI Device
PCI Device
Assignment
Assignment
LPAR manager VNIC
Screen Assignment
Virtual NIC
Promiscuous
Assignment
Mode
VLAN mode
Inter-LPAR
Packet Filtering
TXRATE
LPAR manager Shared FC
Screen Assignment
Shared FC
Assignment

EFI Driver Setting Items

An EFI driver setting items necessary in order to build LPAR manager are
below.
Item
Boot Function
Connection Type Sets the connection form of FC-interface.
Data Rate
Select Boot
Device Enable
Boot Device List
B-6
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Setting items Description
Sets Shared mode or Dedicated mode
Sets an assignment of PCI Device.
Sets Logical NIC.
Sets a promiscuous mode.
Sets a VLAN mode.
Sets between-LPARs communication
packet filter.
Sets a limited transmission bandwidth
of VF NIC.
Sets an assignment of Shared-FC-Port
Table B-2 EFI Driver setting items
Setting Items Description
Sets Enable when San-Boot-function enables.
It is necessary to set Enabled to a FC port of
Boot path.
Sets the Data transfer speed of FC-interface.
Sets Enable when searching Boot-Device that is
registered to Boot-Device-list.
Registers the using Boot Device when select
Boot Device Enable is set Enable.
Setting Item List
Support
default
Version
S 01-0X
or later
- 01-0X
or later
*(non-assign) 01-0X
or later
T(Shared NIC/ 01-0X
Virtual NIC)
or later
R(VF NIC)
*(non-assign) 01-0X
or later
Disable 01-0X
or later
10000Mbps 01-9X or
later
*(non-assign) 01-0X
or later
default
Disabled
Auto
Depends on a
factory-shipments
state
Disabled
(All Zero)